ECG EDF 4516 QA+ - Error Codes

GB
68
Problem Possible cause Corrective action
Yellow or brown  lm
on interior surfaces
Co ee or tea spots Use asolution of 1/2 cup of bleach and 3 cups of water and
remove stains manually.
WARNING!
After completing the program, wait before cleaning the
interior surface for at least 20 minutes to let the heating
elements cool down. Otherwise, there is arisk of burns.
Metal deposits in water can
cause pervasive coating
Contact your water supplier with arequest to install aspecial
 lter.
White coating on the
inner surface.
Hard water containing
minerals
To clean the interior, use asponge soaked in detergent for
dishwashers. Use rubber gloves. Never use any other cleaner
than for dishwasher to prevent formation of foaming or suds.
Detergent dispenser
lid does not close
properly
The residue of detergent
clogged the lid catch.
Remove the residue of the detergent from the catch.
Detergent remained
in the detergent
dispenser trays.
The dishes blocked the
dispenser trays.
Rearrange the dishes.
Steam This is normal Certain amount of steam comes through the ventilation
openings during drying and draining of water.
Black or gray spots on
the dishes.
Aluminium utensils have
rubbed against other dishes.
To remove these stains use amild abrasive cleaner.
Water remains on the
bottom of the sink
This is normal Small amount of water on the bottom of the sink prevents
drying of the water seal.
Water leak from the
dishwasher
Over lling dispenser or spill of
the rinse aid
Make sure that you do not over ll the rinse aid dispenser.
Spilled rinse aid can cause excessive foaming and may lead to
over ow. Wipe the spilled rinse aid using wet cloth.
The dishwasher is not in level
position
Make sure that the dishwasher is in level position.
ERROR CODES
In the event of amalfunction acorresponding error code appears on the dishwasher control panel using the
LED indicators.
Code Meaning Possible cause
E1 Open door Open door during dishwasher running
E2 Water supply Water supply malfunction
E3 Water drainage Water drainage malfunction
E4 Temperature sensor Temperature sensor failure
E5 Over ow/leakage of water Over ow/leakage of water occurred
E6 Water leakage Water leakage occurred
E7 Heating element Heating malfunction
WARNING
• If there is awater leak, close the water inlet valve and contact an authorized service center. If there is on the
 oor of the dishwasher water due to over ow or leak, remove it before restarting the dishwasher.