ECG MK 104 - Exhaust Hose Installation Warnings; Remote Control Setup; Operation; Cooling and Airflow Mode

GB
38
5. Attach the at neck of the exhaust hose assembly in the sealing strip in the window and secure with
screwsC.
A B C
Beware of incorrect installation:
• Good throughput of the exhaust hose is very important. Incorrect installation
aects the performance of the air conditioner.
• Avoid excessive bending of the exhaust hose during installation.
• Ensure smooth airow through the hose.
Notice:
The length of the exhaust hose was specially designed for this model. Do not
replace the hose arbitrarily or extend it since this could easily lead to impaired
function or failure of air conditioning.
Note:
Maximum stretched length of the exhaust hose is 1,5 m. Try to keep the length as short as possible during the
operation. We recommend that the hose is installed as straight as possible.
Remote control
Insert batteries into remote control before use:
1. Push to remove the cover of the battery compartment.
2. Insert two new alkaline batteries. Keep the correct polarity of the batteries
marked in the battery compartment.
3. Replace the battery space cover.
Note:
Use exclusively alkaline batteries in the remote control. Do not use rechargeable batteries or other battery
types.
Replace both batteries in the same time. Do not combine old and new batteries or batteries of various types.
If you do not use the air conditioner for longer time, remove the batteries from the remote control.
Attention:
In the event of battery leakage, wipe the battery compartment so as to prevent corrosion inside the remote
control. Be careful. The electrolyte is corrosive and can cause skin burns or other health risks. In case of splash
on skin or clothing immediately rinse the aected area with water. In case of accidental swallowing see
aphysician.
OPERATION
Cooling and airow mode
• After turning on the air conditioner is in the cooling mode by default. You can also change the air
conditioner in the cooling mode using modes button 5. The cooling indicator is on.
• Using buttons 4 (up and down arrows) set the required temperature in the range from 16 °C to 30 °C.
• Press the air speed button 3 to choose between low, medium and high air speed.