ECG MK 104 - Care and Maintenance; Cleaning External Surface; Cleaning the Filter; Seasonal Maintenance

GB
40
Maintenance
Attention: Turn o the appliance and disconnect it from power before cleaning and maintenance to prevent
injury by electric shock!
Cleaning the external surface
1. Unplug the power supply from the outlet.
2. Wipe it with ane cloth. Do not use benzine, solvent or other chemicals for cleaning. These substances
could damage the surface of the device and deform plastic components.
3. Protect the appliance from water getting in.
Cleaning the lter
We recommend to clean the lter every 14 days. If the air is polluted it is necessary to clean it more often. When
the lter is gradually clogged with dust, the eciency of air conditioning is reduced. When cleaning, do the
following:
1. Remove the input grill and then lter, see picture.
2. Place the lter in a solution of neutral detergent or hot water (40° C) and let it dry in the shade after
washing it.
3. Replace the clean lter back. Turn on the air conditioner and operate it as usual.
Notes:
• To clean the lter do not use overly hot water (ideal temperature is about 40° C) and aggressive cleaning
agents (alcohol, gasoline, paint thinners).
• To avoid deformation of the lter protect it from heat and let it dry by itself.
• Do not operate the appliance without inserted lter.
Seasonal maintenance
If you are not using the appliance for longer time do the following seasonal maintenance:
1. Remove the drain plug and drain the water from the appliance.
2. Let the appliance run for 2 hours in the airow mode until the inside is all dried up.
3. Turn o the appliance and unplug it.
4. Clean the lter and replace it.
5. Remove the exhaust hose assembly and store it carefully.
6. Remove the batteries from the remote control.
7. Put the appliance in aplastic bag and store it in acool and dry place.
Do the following after long term storage of the appliance before using it again:
1. Make sure that the lter and the drain plug are in place.
2. Check the power cord for any damage. When it is damaged, do not use the appliance.
3. Insert batteries in the remote control.
4. Reinstall all accessories in accordance with installation instructions.
If the lter is not too dirty, you can remove the
dust with avacuum cleaner.
Wash heavily soiled lter with warm water.