ECG MK 94 - Care and Maintenance; Emptying the Water Tank

English English
11
CARE AND MAINTENANCE
Emptying the water tank
The appliance has an automatic water evaporation system. The circulation of condensed water cools the
evaporator. This not only increases the eciency of cooling, but also saves energy.
When the water container is full the display shows message “FL” accompanied by acoustic alarm. The
compressor stops working automatically. In this case, water should be poured out. Proceed as follows:
1. Disconnect the appliance from power and remove the exhaust hose assembly.
2. Place the air conditioner in asuitable place.
3. Remove the drain plug and drain the water from the appliance.
4. Carefully replace the drain plug.
5. Replace the exhaust hose and turn on the air conditioning.
Maintenance
Warning: Turn o the appliance and disconnect it from power before cleaning and maintenance to prevent
injury by electric shock!
Cleaning the external surface
1. Unplug the power cable from the electrical outlet.
2. Wipe it with ane cloth. Do not use gasoline, thinner or other chemicals for cleaning. These substances can
damage the surface of the appliance and deform the plastic parts.
3. Protect the appliance from water getting in.
Cleaning the lter
We recommend to clean the lter every 14 days. In case of polluted air, the cleaning frequency should be
increased. When the lter is gradually clogged with dust, the eciency of air conditioning is reduced. When
cleaning, do the following:
1. Remove the input grid and then the lter as shown.
2. Place the lter in aneutral detergent solution or warm water (approx. 40 ° C) and allow it to dry in the
shade after washing.
3. Replace the clean lter back. Turn on the air conditioning and use it as usual.
Notes:
• Do not use excessively hot water (ideal temperature approx. 40 ° C) and aggressive cleaners (alcohol,
gasoline, thinners) to clean the lter.
• Protect the lter from heat to prevent its deformation and allow it to dry freely.
• Do not operate the appliance without inserted lter.
If the lter is not too dirty, you can remove the dust with avacuum cleaner.
Wash heavily soiled lter with warm water.