ECG MK 94 - Page 8

English English
8
Window seal assembly
Remove dirt from the window frame and sash before installation.
Stick the Velcro around the perimeter of the window frame so that the window can close after the sealing has
been attached.
A
B
M
M
B
A
M
B
A
S
M
B
S
A
M
B
A
S
1.
2.
3. 4.
1. Mark the center (M) of the window seal (Fig. 1).
2. Mark the center of the window frame and sash (Fig. 2–4).
- gure 2 shows open window
- gure 3 shows tilted out window
- Figure 4 shows open skylight
3. Attach the Velcro tape to the front of the sash (in most cases 1 cm wide) or to the inner surface of the sash
(on which the window handles are attached).
4. First attach side A, then side B, starting from the center and continuing left and right.
5. IMPORTANT! When attaching, the point Amust be exactly opposite the point B.
6. It is best to open the Velcro in the position marked with «S» and attach the air outlet hose.
• When closing the window, always be careful not to squash the seal.
• The seal is intended for use with windows with amaximum circumference of 400 cm.
Cleaning and maintenance
The seal can be machine washed at 30 ° C
Do not use aggressive cleaners.