BRD-2620 OPERATION
X7502343001 25
© 09/2019 ECHO Inc.
Never adjust blade height while engine is running, otherwise
serious personal injury may result.
7. Loosen adjustment knob (A)
and adjust the blade’s depth of
cut. Tighten adjustment knob
(A) when desired blade height
is achieved.
8. If shield clogs with mud or
debris, do not hit unit against
hard surfaces to clean, or
damage to unit may occur. Stop
engine and unclog shield with a
suitable tool.
Be sure blade has completely stopped spinning before setting unit on
concrete or other hard surface. Never allow spinning blade to contact
hard surfaces. Carbide teeth on blade can break, or damage to
surface can occur.
The complete unit, specifically the drive shaft
assembly and muffler exhaust area may
become very hot during use. Avoid contact
during and immediately after operation, otherwise serious
personal injury may result.
Increase
Depth
Decrease
Depth
A
To Next Page
Loading...
Need help?
General
