OPERATION BRD-2620
26 X7502343001
© 09/2019 ECHO Inc.
Edging Operation
Before edging, be sure to read and understand the entire
Operator’s Manual to avoid the chance of serious personal
injury.
1. Before edging, water the area to soften the ground to make edging
easier.
2. Before edging, check the area and remove all obstacles and objects
that could be thrown.
3. Plan to edge regularly to make it easier to keep a neat edge and to
avoid having to make more than one pass.
Never adjust blade height or clear debris from shield with
engine running, otherwise serious personal injury may result.
Note: Blade depth may have to be adjusted due to differences in
height between the hard surface and the top of the grass.
4. Loosen blade adjustment knob
(A) and adjust the blade’s depth
of cut to produce a fine cut
between sidewalk and grass
using a minimum blade depth,
usually with about 13 mm (0.5
in.) of the blade into the ground.
Tighten adjustment knob.
5. Before edging, plan your direc-
tion of travel so that the unit will
always be on your right side
and so that you walk on a hard
surface whenever possible.
6. Position edger as shown.
7. When starting to edge, run the
engine at full throttle, and lower
the blade gently into the
ground, being careful not to hit
the concrete with the blade.
Increase
depth.
Decrease
depth.
A
To Next Page
Loading...
Need help?
General
