Echo CS-271T - OPERATION; Chain Lubrication

16
CS-271T
WHEN THE ENGINE IS COLD
CAUTION
Make sure the bar and chain are free from
any obstruction when starting the chain saw.
• Movechainbrakeleverfullyforwardtolock
chain brake before starting.
• Fillthefueltankwithfuelmixture.
It is not permitted to fill fuel above the shoulder
level of fuel tank.
• Fillthechainoiltankwithlubricant.
Do not over fill.
• Moveignitionswitchto“Run” position.
• Pushpurgepump3to4timesoruntilfuelis
visible in purge pump.
• Turnchokecontrolknobcounterclockwise.
(Choke position
)
• Securelyholdthechainsawasshown.
When starting the chain saw place the unit on
a flat ground and hold the front handle with left
hand and hold firmly the rear end of rear handle
with right knee and pull starter handle with right
hand several times until first firing sound.
• Turnchokecontrolknobclockwise.
(Open position
)
• Pullstarterhandletostarttheengine.
• Whenenginestarts,immediatelysqueezeand
release throttle trigger for disengaging throttle
latch and returning engine to idle, and pull front
hand guard towards the operator immediately.
(Chain brake unlocked position)
WHEN THE ENGINE IS WARM
CAUTION
Make sure the bar and chain are free from
any obstruction when starting the chain saw.
• Movechainbrakeleverfullyforwardtolock
chain brake before starting.
• Conrmthereisfuelandchainoilinthetanks.
• Moveignitionswitchto“Run” position.
• Securelyholdthechainsawasshownandpull
starter handle.
• Chokemaybeusedifnecessary,butafterrst
firing sound, pull throttle trigger to release choke.
• Afterstartingtheengine,pullfronthandguard
towards the operator immediately.
(Chain brake unlocked position)
Open choke
Choke control knob
Chain brake
Start / Run
Ignition switch
Purge pump
Choke
Choke control knob
Starter handle
Unlock chain brake
Chain brake
Unlock chain brake