What to do if there is no spark at the spark plug in my Echo CS-350TES Chainsaw?
If there's no spark at the spark plug, the spark gap might be incorrect and needs adjustment to 0.6 to 0.7 mm. The spark plug could also be covered with carbon or fouled with fuel, requiring cleaning or replacement. If the spark plug is defective, replace it.
How to fix no fuel at the carburettor of my Echo CS-350TES Chainsaw?
If there's no fuel at the carburettor when you crank your Echo Chainsaw, the fuel filter or fuel line might be clogged and require cleaning or replacement. The carburettor itself may also be clogged and need to be cleaned. If you are not sure, ask your ECHO dealer.
What to do if there is no spark at the end of the plug wire of my Echo Chainsaw?
If there's no spark at the end of the plug wire, check if the ignition switch is turned off and turn it on. If the switch is already on, there may be an electrical problem. If you are not sure, ask your ECHO dealer.
What to do if my Echo CS-350TES has no spark at the plug?
If there's no spark at the plug of your Echo Chainsaw, it might be due to an incorrect spark gap. Adjust it to 0.6 to 0.7 mm. Alternatively, the spark plug might be covered with carbon or fouled with fuel, in which case you should clean or replace it. The spark plug itself could also be defective, requiring replacement.
Why is my Echo CS-350TES silencer wet with fuel?
If the silencer of your Echo Chainsaw is wet with fuel, it's likely that the fuel mixture is too rich. Try opening the choke, cleaning or replacing the air filter, or adjusting the carburetor. For further assistance, consult your ECHO dealer.
What to do if my Echo CS-350TES has no fuel at carburettor?
If your Echo Chainsaw has no fuel at the carburettor, the fuel filter or fuel line might be clogged. Try cleaning or replacing the fuel filter and cleaning the fuel line. For carburettor issues, consult your ECHO dealer.
Why does my Echo CS-350TES engine run poorly and then die?
Your Echo Chainsaw engine might run poorly and die due to several reasons. The air filter or fuel filter could be dirty and need cleaning or replacing. A plugged fuel vent, a faulty spark plug, or a misadjusted carburettor could also be the cause. Additionally, check if the cooling system or exhaust port/silencer are plugged and clean them if necessary.
Why is the silencer of my Echo CS-350TES Chainsaw wet with fuel?
If the silencer is wet with fuel, the fuel mixture might be too rich, try opening the choke. Also, the air filter may need cleaning or replacement, or the carburettor may need adjustment. If you are not sure, ask your ECHO dealer.
Why does my Echo CS-350TES engine run but dies or accelerates poorly?
Your Echo Chainsaw might be experiencing issues like a dirty air filter, fuel filter, or a plugged fuel vent. Other potential causes include a fouled spark plug, carburetor issues, a plugged cooling system, or a blocked exhaust port/silencer. You can try to clean or replace the air filter, fuel filter, clean the fuel vent, clean and adjust or replace the spark plug, adjust the carburettor, clean the cooling system, or clean the exhaust port/silencer.
What to do if my Echo CS-350TES has no spark at end of plug wire?
If there is no spark at the end of the plug wire of your Echo Chainsaw, first ensure the ignition switch is turned on. If the problem persists, it may be an electrical issue, and you should consult your ECHO dealer.
General| Bar Length | 30 cm |
|---|---|
| Engine Type | 2-stroke |
| Engine Displacement | 34.0 cc |
| Oil Tank Capacity | 0.23 L |
| Chain Pitch | 3/8 inch |
| Chain Gauge | 0.050 inch |
To Next Page
