CS-350WES
12
STARTER SYSTEM
2-4 Replacing starter pawl
1. Remove starter assembly from unit.
2. Loosen bolt (C), and remove pawl (A), washers,
spacer (B) and spring. Replace damaged or worn
parts.
NOTE: When it is hard to loosen the bolt, use
flexible wrench 897709-79920 to hold flywheel to
remove them easily.
8. Fasten screw (P) on starter post.
9. Pull out starter rope inside starter case. Rotate
rope reel clockwise several turns with rope hooked
at notch (Q) as shown. Hold the rope reel to prevent
it from rewinding and pull out starter grip out to take
the rope slack.
P
Q
(C)
(B)
(A)
2-3 Assembling starter (continued)
10. Pull starter several times to check the rewind
spring tension. If the starter is not rewinding fully,
rotate the drum one more turn clockwise following
above step (9).
11. Pull the starter rope all the way out and check
that the rope reel can be rotated an additional half
or more turn clockwise.
12. If it is less than half turn, there is a chance to
break rewind spring. In this case, pull out starter
rope about 30 centimeter (12 in), and hold rope reel.
Then pull starter rope inside starter case and rotate
rope reel one turn counterclockwise with rope
hooked at notch.
To Next Page
Loading...
