20 X7503320105
© 09/2013 ECHO Inc.
OPERATION CS-355T
Starting Cold Engine
Make sure the bar and chain are free from any obstruction
when starting the chain saw.
1. Move chain brake lever fully forward to lock chain brake
before starting.
2. Fill the fuel tank with fuel mixture. Do not over fill.
3. Fill the chain oil tank with lubricant. Do not over fill.
4. Move control lever (choke/ignition switch) (A) forward to
(close choke
) position.
5. Push purge pump (B) 3 to 4 times or until fuel is visible in
purge pump.
6. Lay unit on a flat, clear area and keep bar and chain clear of
all obstacles. Securely hold and pull starter handle several
times until engine starts, or first starting sound is heard. (7
pulls maximum)
7. Move control lever (choke/ignition switch) to (RUN ( I ))
position. (Do not move to “Stop” position.) If necessary,
restart the engine.
• After starting the engine, immediately squeeze and then release throttle trigger to release fast idle
throttle latch, otherwise severe brake damage may occur.
• Never use fast idle throttle latch for cutting.
• Use the fast idle throttle latch only in starting.
Note: If engine does not start after 5 pulls, repeat instructions.
Note: Do not increase engine speed while chain brake is locked.
Severe brake damage will result.
For more information
scan this QR code.
To Next Page
Loading...
Need help?
General
