16
CSG-7410
Adjusting the Wheel Guard Angle
1. The wheel guard can be adjusted to prevent debris from flying off and hitting the
operator.
2. Turn the wheel guard locking knob counterclockwise, grasp the wheel guard
knob and move the wheel guard to the desired position, then slowly release it and
secure the wheel guard with the locking knob.
* Never operate the machine without the guard stopper in place.
WARNING
Never operate the machine without the wheel guard in place.
Wheel guard
Locking knob
Wheel guard
WARNING
Before tightening, check that flanges are properly seated and not
cocked on the mount or bolt threads. Do not make bolt so tight
as to destroy the cushion supplied by the wheel blotters. Do not
use pneumatic, electric-powered tools or one’s body weight for
tightening. Otherwise the thread could be broken. Do not tighten
more than 30 N•m (300 kgf•cm).
NOTE
Arm may be removed and remounted with wheel on the outboard side of
the arm as required for certain procedures.
Reverse Mounting the Cutter Arm
When shipped the cutting wheel is mounted so it is near the center of gravity of
the machine. The cutting wheel can be moved to a position outside the machine
by reverse mounting the cutter arm.
WARNING
Reverse mounting the cutter arm compromises the balance of
the machine and makes it difficult to operate. Do not use it in the
reversed state except when necessary.
1. Remove the cutting wheel.
2. Remove the 2 screws and remove the guard stopper.
3. Remove both of the pipes connected to the pipe connector. Remove the pipe
connector after removing the nut mounted on the wheel guard.
4. Mount the pipe connector in the lower hole in the wheel guard.
5. Loosen the nut that holds the nozzle in place.
6. Remove the wheel guard knob mounted on the wheel cover.
Guard Stopper
Pipe
connector
Pipe
Nozzle
Wheel guard knob
Wheel guard knob
To Next Page
Loading...
Need help?
General
