32
CSG-7410
STORAGE AFTER USE
• Inspect and adjust every part of the engine cut-
off saw.
- Completely clean every part and repair if
necessary.
- Apply thin coating of oil on metal parts to
prevent rust.
• Remove wheel.
• Drain fuel tank, pull starter slowly a few times to
drain fuel from carburetor.
• Pour a small amount of clean motor oil into spark
plug hole, pull starter and crank the engine until
piston reaches: TOP DEAD CENTER.
• Store in a dry area, free from dust.
WARNING
Do not store in an enclosure where fuel
fumes may accumlate or reach an open flame
or spark.
CAUTION
Do not lend or rent your engine cut-off saw
without the Operator's Manual.
NOTE
• For future reference, you should keep this
Operator's Manual.
• If this Operator's Manual has become illegible
or is lost, please purchase a new one from your
ECHO dealer.
WARNING
Momentary stop switch automatically
returns to run position. Engine can start
unintentionally when starter handle is pulled.
Always remove spark plug lead from spark
plug before pulling starter handle, otherwise
severe personal injury may result.
To Next Page
Loading...
Need help?
General
