8
CSG-7410
Read this engine cut-off saw operator’s manual carefully.
Be sure you understand how to operate this saw properly before you use it.
Establish a training program for engine cut-off saw operators.
Use safety footwear, snug-fitting clothing and protective gloves.
Wear eye, hearing and head protection devices. Use ballistics chaps or pants
when necessary. Clothing of fire-resistant and non-meltable material should
be worn by emergency crews exposed to flames or high heat conditions.
Use caution when handling fuel. Put the fuel tank caps back tightly on both
the fuel container and the saw tank, move at least 3 m (10 ft.) from the
fueling point, and be sure there is no leakage of fuel from the fuel tank cap or
the fuel system before starting the engine. Avoid ignition from sparks.
DANGER
After refuelling, tighten fuel cap firmly and check for leakage.
In case of fuel leakage repair before starting operation since there is
a danger of fire.
WARNING
Do not run the engine indoors, or where there is poor ventilation.
Engine fumes contain deadly poisonous carbon monoxide.
IMPORTANT
Check before every use.
After refuelling, make sure fuel does not leak from around fuel pipe, fuel
grommet or fuel tank cap.
In case of fuel leakage there is a danger of fire. Stop using the machine
immediately and request your dealer to inspect or replace.
It is not permitted to fill fuel above the shoulder level of fuel tank.
Operate this gasoline engine cut-off saw only in well-ventilated areas.
Do not store the unit with fuel in its tank, because a fuel leak could start a
fire.
Do not cause sparks in any area where there are flammable materials.
Start the engine cut-off saw on the ground with the cutting wheel completely
in the clear.
Do not drop-start the engine cut-off saw, or start it if the wheel is obstructed
by the ground or any other object.
Do not allow other persons to be closer than 9 m (30 ft.) when you are
starting or cutting with the saw. Bystanders should wear hearing and eye
protection. Do not start cutting unless you have good footing and the work
area is clear.
Do not let someone hold the work you are cutting.
Adjust the wheel guard to a position where the sparks and debris from the
wheel will be thrown away from you. Turn the wheel guard locking knob
counterclockwise, grasp the wheel guard knob and move the wheel guard to
the desired position, slowly release it and secure the wheel guard with the
locking knob. Do not operate if the wheel guard is damaged, missing from
the unit, improperly positioned, or cannot be locked in proper position.
OPERATOR SAFETY PRECAUTIONS
3 m
Adjust Wheel guard
Wheel guard locking knob
CSG-7410
WARNING
Read the instructions carefully and follow the rules for safe
operation.
Failure to do so could result in serious injury.
OPERATOR’S MANUAL
ENGINE CUT-OFF SAW
X750 395-410 0
ECHO, INCORPORATED
400 Oakwood Road, Lake Zurich, Illinois 60047-1564
Phone : 847-540-8400
Printed in USA
To Next Page
Loading...
Need help?
General
