19
CSG-7410
Mixing Instructions
1. Fill an approved fuel container with half of the re-
quired amount of gasoline.
2. Add the proper amount of 2-stroke oil to gasoline.
3. Close container and shake to mix oil with gasoline.
4. Add remaining gasoline, close fuel container, and
remix.
Fuel to Oil Mix – 50:1 Ratio
US Metric
Gas Oil Gas Oil
gal. fl.oz. L cc
1 2.6 5 100
2 5.2 10 200
5 13 25 500
NOTICE
Stored fuel ages. Do not mix more fuel than
you expect to use in 30 days, 90 days when a
fuel stabilizer is added.
Stored two-stroke fuel may separate.
ALWAYS shake fuel container thoroughly
before each use.
Used oil and gasoline, and soiled towels are
hazardous waste materials. Disposal laws
vary by locality.
EMISSION DATA
EMISSION CONTROL
(EXHAUST and EVAPORATIVE)
EPA 2010 and Later and/or C.A.R.B. TIER III
The emission control system for the engine is EM
(engine modification) and, if the second to last
character of the Engine Family on the Emission
Control Information label (sample below) is “C”, “K”,
or “T”, the emission control system is EM and TWC
(3-way catalyst). The fuel tank/fuel line emission
control system is EVAP (evaporative emissions).
Evaporative emissions for California models may
only be applicable to fuel tanks.
An Emission Control Label is located on the
engine ( example only, information on label varies
by engine family).
PRODUCT EMISSION DURABILITY
(EMISSION COMPLIANCE PERIOD)
The 300 hours emission compliance period is
the time span selected by the manufacturer
certifying the engine emissions output meets
applicable emissions regulations, provided that
approved maintenance procedures are followed
as listed in the Maintenance Section of this
manual.
EMISSION CONTROL INFORMATION
ENGINE FAMILY: #EHXS.0735RA DISPLACEMENT: 73.5 cc
EMISSION COMPLIANCE PERIOD: 300 Hours
THIS ENGINE MEETS U.S. EPA EXH/EVP EMISSION
REGULATIONS FOR MODEL YEAR **** REFER TO OWNER’S MANU-
AL FOR MAINTENANCE SPECIFICATIONS AND ADJUSTMENTS.
***XXXX
To Next Page
Loading...
Need help?
General
