Echo CSG-7410 User Manual

31
CSG-7410
Troubleshooting Cutting Problems
Troubleshooting Engine Problems
Trouble Probable Cause Remedy
Wheel stops when cutting pressure
is applied
1. Bearing down too hard
2. Binding in crooked cut
3. Binding in closing cut
4. Loose belt
1. Ease up cutting pressure
2. Lay out and follow a straight line
3. Support material so cut will open
4. Increase belt tension
Wheel stops when cutting pressure
is applied
Belt worn beyond the limit Replace belt
Poor cutting – wheel discolored at
outer area
Heat damage
Replace wheel.
Do not cut long in one spot.
Water flush when recommended.
Trouble Probable Cause Remedy
Engine will not start
1. Out of fuel 1. Fill fuel tank
2. Engine flooded 2. Remove spark plug
• Push in and hold the momentary STOP
switch
• Crank the engine to expel the fuel
• Install clean, dry, properly gapped spark plug
3. Fuel filter clogged 3. Install clean fuel filter.
Check that fuel pick-up line is not leaking or
clogged.
Clean fuel tank.
4. Air filter blocked 4. Replace air filter element
5. Spark plug fouled or cracked 5. Replace plug.
6. Ignition magneto or spark
plug wire faulty
6. Contact nearest authorized ECHO servicing
dealer
Engine hard to start
1. See reasons under “will not
start”
1. See remedies above
2. Water in fuel or fuel has gone
stale or sour
2. Fill tank with clean, fresh fuel mixture
3. Engine not getting the proper
fuel / air mixture
3. If over-choked and flooded:
• Remove spark plug
• Push in and hold the momentary STOP
switch
• Crank the engine to expel the fuel
• if not choked enough, set controls properly
for starting
4. Carburetor out of adjustment 4. See “Carburetor Adjustment” or seek
authorized dealer for adjustment
Engine misses
1. Dirt in Carburetor or fuel line 1. Contact nearest authorized servicing dealer
2. Carburetor out of adjustment 2. Adjust, or seek dealer service
3. Weak or intermittent spark 3. Contact nearest authorized servicing dealer
Engine overheats
and / or stalls under
cutting load
1. Not enough oil 1. Use proper amount of oil in fuel mixture
2. Air passages around cylinder
clogged
2. Clean air intake grid on starter side, flywheel,
cylinder fins and surrounding area
3. Carburetor main adjustment
is set too “Lean”
3. See “Carburetor Adjustment” or seek
authorized dealer for adjustment

Echo CSG-7410 Specifications

General

Brand	Echo
Model	CSG-7410
Category	Saw
Language	English