Echo DCS-5000 User Manual

DCS-5000
9992220570838
© 08/2021 ECHO Incorporated
The motor runs and
the chain rotates, but
the chain does not
cut.
The chain is dull.
Sharpen or replace the
saw chain.
The chain is in the
incorrect direction.
Turn the chain loop to
the other direction.
The chain is tight or
loose.
Adjust the chain
tension.
The motor does not
run.
The chain brake is
engaged.
Pull the chain brake
in the direction of the
user to disengage it.
The machine and battery
are not connected
correctly.
Make sure that the
battery release button
clicks when you install
the battery.
The battery level is low. Charge the battery.
The trigger switch
lockout and the trigger
switch are not pushed at
the same time.
1. Push the trigger switch
lockout and hold it.
2. Push the trigger switch
to start the machine.
The battery is too hot or
too cold.
Refer to battery and
charger manual.
The motor runs, but
the chain does not
cut correctly, or the
motor stops after
around 3 seconds.
The machine is in the
protection mode.
Release the trigger
switch and start the
machine again. Do not
force the machine to cut.
The battery is not
charged.
Charge the battery.
Refer to the battery
and charger manual
for correct charging
procedures.
The chain is not
lubricated.
Lubricate the chain to
decrease the friction.
Do not let the guide bar
and the chain operate
without sufcient oil.
Incorrect battery storage
temperature
Cool the battery until
it decreases to the
ambient temperature.
TROUBLESHOOTING

Echo DCS-5000 Specifications

General

Brand	Echo
Model	DCS-5000
Category	Chainsaw
Language	English