Echo DCS-5000 User Manual

37
DCS-5000
99922205708
© 08/2021 ECHO Incorporated
TROUBLESHOOTING
TROUBLESHOOTING
Problem Cause Solution
The guide bar and
the chain become
hot and release
smoke.
The chain is too tight.
Adjust the chain
tension.
The oil tank is empty. Add oil.
Contamination causes
a blockage of the
discharge port.
Remove the guide
bar and clean the
discharge port.
Contamination causes a
blockage of the oil tank.
Clean the oil tank. Add
new oil.
Contamination causes
a blockage of the guide
bar and the oil tank cap.
Clean the guide bar
and the oil tank cap.
Contamination causes a
blockage of the sprocket
or guide wheels.
Clean the sprocket and
the guide wheels.
The motor runs but
the chain does not
rotate.
The chain is too tight.
Adjust the chain
tension.
The guide bar and the
chain are damaged.
Replace the guide bar
and the chain if it is
necessary.
The motor is damaged.
1. Remove the battery
from the machine.
2. Remove the guide
bar scabbard.
3. Remove the bar and
saw chain.
4. Clean the machine.
5. Install battery and
operate the machine.
If the sprocket rotates,
it means the motor
works properly. If not,
call an Authorized
ECHO Dealer.

Echo DCS-5000 Specifications

General

Brand	Echo
Model	DCS-5000
Category	Chainsaw
Language	English