Sh a f t he d g e Cl i p p e r
13
Op e r a t O r ’S Ma n u a l
a d j u s t I n g c u t t I n g a n g l e
WARNING
Never adjust cutting assembly with engine running.
WARNING
Hedge clipper blades are sharp. Always wear gloves when adjust-
ing cutting assembly.
WARNING
DO NOT stand hedge clipper on end when adjusting cutting angle,
otherwise serious injury may result
1. Place unit on a at clear area. Assure stop switch is in the “STOP”
position.
2. Pull out indexing ring (A), and turn ¼ turn to lockout position.
3. Turn hedge clipper ¼ turn so that indexing ring faces downward.
4. Release hand-guard blade lock (B) with right hand, while holding
blade-adjustment handle (C) with left hand.
5. Rotate blades to desired cutting position.
6. Turn indexing ring ¼ turn to lock blade in place.
WARNING
Gear case assembly becomes HOT during use. Always grip assem-
bly at blade-adjustment handle when making cutting angle adjust-
ments, otherwise serious injury may result.
A
B
C
B
To Next Page
Loading...
