Echo SRM-210 - 11-03 SERIAL NUMBER 07001001-07004401 - Specifications

GRASS TRIMMER/BRUSH CUTTER
OPERATOR'S MANUAL
11
SPECIFICATIONS
* Install and use U-Handle when operating any model with blade.
MODEL -----------------------------------------------------SRM-210
Length------------------------------------------------------- 1770 mm (69.7 in.)
Width-------------------------------------------------------- 250 mm (9.84 in.)
Height ------------------------------------------------------- 325 mm (12.8 in.)
Weight (dry) w/cutter head ------------------------------- 4.8 kg (10.7 lb.)
Engine Type ------------------------------------------------Air cooled, two-stroke, single cylinder gasoline engine
Bore ----------------------------------------------------------32.2 mm (1.27 in.)
Stroke--------------------------------------------------------26.0 mm (1.02 in.)
Displacement -----------------------------------------------21.2 cc (1.29 cu. in.)
Exhaust ------------------------------------------------------Spark Arrestor Muffler
Carburetor --------------------------------------------------Zama model w/purge pump
Ignition System -------------------------------------------- Flywheel magneto, capacitor discharge ignition type
Spark Plug -------------------------------------------------- NGK BPMR-8Y Gap 0.65 mm (0.026 in.)
Fuel ----------------------------------------------------------Mixed (Gasoline and Two-stroke Oil)
Fuel/Oil Ratio ----------------------------------------------- 50:1 two-stroke air cooled engine oil
Gasoline ----------------------------------------------------- 89 Octane unleaded. DO NOT use fuel containing methyl alcohol,
more than 10% ethyl alcohol or 15% MTBE.
Oil ------------------------------------------------------------Power Blend
TM
Premium Universal 2-Stroke Oil
Fuel Tank Capacity ---------------------------------------- 0.45 lit. (15.2 US fl. oz.)
Recoil Starter System --------------------------------------Automatic Recoil Starter
Clutch ------------------------------------------------------- Centrifugal Type
Drive Shaft --------------------------------------------------1/4 in. Flex Shaft
Rotating Direction -----------------------------------------Counter-Clockwise viewed from top
Cutter Head -------------------------------------------------Nylon line head (2-line) with .095 Crossfire™ Line capacity
6m (20 ft.)
Handle* ----------------------------------------------------- Front - Loop and Right Rear Handle w/rubber grips
Shoulder Harness ------------------------------------------ Optional
Idle Speed RPM --------------------------------------------2,400 - 3,200
Wide Open Throttle Speed (W.O.T.) RPM -------------8,000 - 9,000
IMPORTANT This spark ignition system complies with Canadian ICES-002.