GRASS TRIMMER/BRUSH CUTTER
OPERATOR'S MANUAL
31
1. Remove spark plug lead
2. Loosen outer throttle cable nut (A) and remove cable from engine
housing bracket slot.
3. Remove two (2) engine cover screws at top of starter.
4. Remove screw and arm rest (B). Lift cover (C) from engine.
5. Use the wooden stick or brush to remove dirt form cylinder fins.
6. Remove grass and leaves from the grid between the recoil starter and
fuel tank.
7. Assemble components in reverse order.
NOTE
When installing the cover, be certain the tab of the metal deflector
shield is in the slot of the engine cover.
A
B
C
To Next Page
Loading...
