ENGLISH
• NEVER start a unit near a gasoline
container or spilled gasoline.
• ALWAYS move at least 3 m (10 ft.)
away from refueling location before
starting engine.
• If a protective blade cover is used,
ALWAYS remove blade cover before
starting unit. Keep blade cover nearby,
and place cover back on blade when
unit is off and blade has stopped.
• NEVER start a PAS/HCA (extended
shaft, articulating blade) unit while
blade is in folded/locked position. Make
cutting angle adjustment rst.
• ALWAYS start the unit with power head on the
ground, with cutting head/work attachment off the
ground and clear of debris and all obstructions.
• NEVER “drop start” the unit or attempt to start the
unit while it is resting on blade tips.
• ALWAYS grip the unit rmly when starting to
prevent loss of control when pulling starter handle.
• ALWAYS hold the unit securely on the right side
of your body with both hands. Use left hand on the
front handle and right hand on the rear handle,
or use left and right handgrips on units equipped
with U-Handle for metal blade use.
• MAINTAIN a secure, two-handed grip at all times
while unit is in use.
• ALWAYS shut unit off immediately if it shakes or
vibrates excessively when started. Tag unit, and
have it checked by an authorized service center
before placing back in use.
Do not start within 3 m (10 ft.)
of fueling location
To Next Page
Loading...
Need help?
General
