EasyManua.ls Logo

Echo TC-2100 - PRE-OPERATION; FUEL REQUIREMENTS; HANDLING FUEL

Echo TC-2100
28 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
12
PRE-OPERATION
FUEL
Fuel Requirements
Gasoline - Use 89 Octane [ ] gasoline or gasohol known to be good
quality. Gasohol may contain up to 10% Ethyl (grain) alcohol or 15%
MTBE (methyl tertiary-butyl ether). Gasohol containing methanol
(wood alcohol) is NOT approved.
Two-Stroke Oil - A two-stroke engine oil meeting ISO-L-EGD
Standard (ISO/CD 13738), must be used. Echo brand Premium 50:1 oil
meets this standard. Engine problems due to inadequate lubrication
caused by failure to use an ISO-L-EGD approved oil, such as Echo
Premium 50:1 Two-stroke Oil, will void the two-stroke engine war-
ranty. (Emission related parts only are covered for two years, regard-
less of two-stroke oil used, per the statement listed in the EPA Phase I/
California Emission Defect Warranty Explanation.)
Mixing - Follow directions on the oil container.
Handling Fuel
WARNING DANGER
Fuel is VERY flammable. Use extreme care when mixing, storing
or handling or serious personal injury may result.
- Use an approved fuel container.
- DO NOT smoke near fuel.
- DO NOT allow flames or sparks near fuel.
- Fuel tanks/cans may be under pressure. Always loosen fuel caps
slowly allowing pressure to equalize.
- NEVER refuel a unit when the engine is HOT!
- NEVER refuel a unit with the engine running.
- DO NOT fill fuel tanks indoors. ALWAYS fill fuel tanks
outdoors over bare ground.
- Securely tighten fuel cap after refueling.
- Inspect for fuel leakage. If fuel leakage is found, do not start or
operate unit until leakage is repaired.
IMPORTANT
Spilled fuel is a leading cause of hydrocarbon emissions. Some
states may require the use of automatic fuel shut-off containers
to reduce fuel spillage. Contact your ECHO dealer for ordering
information.
R + M
2

Related product manuals