EasyManuals Logo

Echo TC-210i User Manual

Echo TC-210i
24 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #12 background imageLoading...
Page #12 background image
12
OPERATION
STARTING
COLD ENGINE
WARNING DANGER
The tines should not move at idle. If tines move, readjust carburetor
according to "Carburetor Adjustment" instructions in this manual
or see your ECHO Dealer, otherwise serious personal injury may
result.
1. Stop Switch
Move Stop Switch (A) to "START" position.
2. Choke
Move choke (B) to "COLD START" position. Throttle must remain
at idle position for starting.
3. Primer
Pump primer bulb (C) until fuel is visible and flows freely in the
clear fuel tank return line. Pump bulb an additional 4 or 5 times.
NOTE
Energy is stored in the starter spring each time the handle/rope is
pulled. Generally two to six pulls, using light pulling forces, will
store enough energy to engage the starter and spin the engine. Do
not pull the rope out to end stop.
4. Recoil Starter
Gently pull recoil starter handle/rope (D) until engine fires or 2 to 3
engine engagements.
5. Choke
After engine fires or 2 to 3 engine engagements, move choke (B) to
RUN (open) position.
6. Recoil Starter
Pull recoil starter rope until engine starts.
NOTE
If engine does not start with choke in “Run” position after 5 engine
engagements, repeat instructions.
7. After engine warm up, gradually depress throttle trigger to increase
engine RPM to operating speed.
C
A
B

Other manuals for Echo TC-210i

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Echo TC-210i and is the answer not in the manual?

Echo TC-210i Specifications

General IconGeneral
BrandEcho
ModelTC-210i
CategoryTiller
LanguageEnglish

Related product manuals