TILLER/CULTIVATOR
OPERATOR'S MANUAL
13
STARTING WARM ENGINE
The starting procedure is the same as cold start except DO NOT close
the choke (B).
NOTE
If engine does not start after 5 engine engagements, use Cold Start
Procedure.
1. Stop Switch
Move Stop Switch (A) to START position. Throttle trigger must
remain at idle position for starting.
2. Primer
Pump primer bulb (C) until fuel is visible and flows freely in the
clear fuel tank return line. Pump bulb an additional 4 or 5 times.
3. Choke
Be certain choke (B) is in "RUN" position.
4. Recoil Starter
Pull recoil starter rope until engine starts.
STOPPING ENGINE
1. Throttle Trigger
Release throttle and allow engine to return to idle before shutting
engine off.
2. Stop Switch
Move stop switch to "STOP" position (A).
WARNING DANGER
If engine does not stop when stop switch is moved to STOP
position, close choke - COLD START position - to stall engine.
Have your ECHO dealer repair stop switch before using tiller/
cultivator again.
A
B
C
A
To Next Page
Loading...
Need help?
General
