14
OPERATION
NOTE
Refer to your Pro Attachment Series power source or Split Boom
Operator's Manual for correct engine fueling, starting and stop-
ping instructions.
PRUNING TECHNIQUES
The Power Pruner™ Attachment is designed for light to medium
trimming of limbs and branches up to 203 mm (8 in.) in diameter.
Follow these tips for successful operation.
• Plan cut carefully. Check direction branch will fall.
• Long branches should be removed in several pieces.
• Do not stand directly beneath branch being cut.
• When ready to cut:
Hold "cutting shoe" against branch. This will prevent whipping of
the branch. DO NOT use back and forth sawing action.
• Look out for branches immediately behind the branch being cut. If
saw chain hits rear branch damage to the saw chain my occur.
• Accelerate to full throttle.
• Apply cutting pressure.
• Ease cutting pressure when nearing end of cut to maintain control.
• When pruning a limb 102 mm (4 in.) diameter or larger cut as
follows:
1.Under cut 1/4 limb diameter near tree trunk.
2.Finish top cut slightly farther out on limb.
3.Flush cut stub at trunk.
• DO NOT use for felling or bucking.
CORRECT
GUIDE AGAINST
BRANCH
NOT
CORRECT
BLADE HITS REAR BRANCH
NOT
CORRECT
To Next Page
Loading...
Need help?
General