EchoStar DISH 500+ - DISH Pro Plus 500+ and 1000+ LNBF Assembly with Port; Mast Bolts

8
For DISH Pro Plus LNBF assembly: Connect the tempoary cable to Port 1 (119°W) of the
LNBF(seeFigure6).
Figure 6: DISH Pro Plus 500+ and 1000+ LNBF Assembly with Port 1 (119°W)
Peak the reector for signal on the 119°W.Peakthereectorforsignalonthe119°W
satellite sign and transponder 13 using the azimuth and elevation settings you wrote on page 4.
Do not adjust the skew.
Note:Ifyoucannotndthe119°Wsignal,tryadjustingtheelevationupordownoneortwo
degrees.Ensureyouarepeakingthereectorusingtransponder13.
Tighten three mast bolts and reconrm signal strength. With the peaking meter still
connected, tighten the three mast bolts labeled with a T to the torque values listed in Table 1 (see
Figure7).Reconrmsignalstrengthaftertighteningthebolts.
Figure 7. Mast bolts
4.
LNB In
LNB In
Mast
Bolts
3.