Echowell echo a1 - In General Mode

9
setting.
Button C:
1. In General Mode, press the C button to enter Data
Setting Mode.
2.In Data Setting Mode, press the C button to exit and
return to General Mode.
Button D:
No function.
How do you enter Data Setting Mode after initiating the computer?
After initiating the computer by pressing the A, B, C buttons at the same
time for 3 seconds, press any button to quit auto-testing display, and
then select units. After unit selection, press the B button for 2 seconds
to enter Data Setting Mode.
2. In General Mode:
Tips:
1. The buttons you'll use in General Mode: A, B, C, D
2. Button for changing the function display: A
3. Button for resetting the trip data: A (3's)
4. Button for entering Data Setting Mode: C
5. Buttons for entering Altitude Calibration Mode: A+B (3's)
Button A:
1. Press the A button to move to the next function
display.
2. Press the A button for 3 seconds, and you will
reset the following data:
AVG SPD, MAX SPD, DST, RTM, ALT, MAX ALT,
AVG RPM, MAX RPM.
(AVG RPM and MAX RPM are for Echo-a2 only.)
Button B:
1. Press the B button to turn on the EL backlight.
2. The following function is for Echo-a2 only:
Press the B button for 1 second, and the
temperature will be displayed.
Button C:
Press the C button, and you'll enter Data Setting
Mode.
Buttons A+B:
Push both buttons for 3 seconds, and you'll enter