Reverb
The effect recreates the sound waves decaying in an acoustic space due to bouncing off on walls, ceilings, objects
etc … The user can adjust the “Environment dimension” acoustics as well as the “Reverb” time (Decay Time, the
time it takes for the reverb to die off).
TIME
PARAMETER
Reverb
Environment Dimension
Room Size
from “Small Room” to “Church”
Decay Time
Flanger
This effect is a variable flanged delay linked to a Beat Per Minute controlled sinewave low frequency oscillation
(L.F.O.). This produces a dynamic swirling sound effect.
Long Flanger over 4 beat-patterns (= over 16 beats) will create a very smooth “space” ambiance to your mix.
TIME
PARAMETER
Flanger
Flange Speed
L.F.O. cycle length
from 0.5 to 8 beat-pattern*
Short Delay adjustment
Minimum Delay from 0.1ms (0%) to 6ms (100%)
* 1 beat-pattern = 4 beats
Phaser
A Phaser effect is a time-varying all pass filter that works by shifting portions of the audio signal out of phase
(±180º), and then adding the processed signal back to the original one. These frequencies are shifted following a
Beat Per Minute controlled low frequency oscillation (L.F.O.) which creates a sweeping phaser sound. The
feedback adjustment raises the filter gain just below each notch in the frequency range, creating a more
pronounced effect.
Long Phaser over 4 beat-patterns (= over 16 beats) will create a very smooth “space” ambiance to your mix. For
"singing" phaser sounds, raise the feedback adjustment.
TIME
PARAMETER
Phaser
Phasing Speed
L.F.O. cycle length
from 0.5 to 8 beat-pattern*
Phaser Feedback %
* 1 beat-pattern = 4 beats
To Next Page
Loading...
