10
7. INSTALLATION AND CONNECTION
Warm2 is conceived as a portable desktop mixer with a small form factor and
optimized to be placed between two turntables or two digital players.
We recommend to place it in a comfortable position for the end user, without placing
it in direct contact with the turntables to avoid transmitting shocks and vibrations to
the styluses during use.
Because of the high gain of the PHONO and MICRO inputs, always try to place the
mixer as far away as possible from noise sources (dimmers, engines, etc.) and mains
wires.
The WARM2 operates with a universal input power supply and can perfectly works
without any internal modification from 90V to 264V – 47 to 63Hz. Ensure that the
mains-wire is far away from the signal-cables in order to avoid any possible audio
hum.
In order to protect the unit from an eventual electrical overload it carries a T 0.5A
fuse. Should it ever blow up, unplug the unit from mains and replace it with an
identical one. If the new fuse blows again contact immediately with our authorized
technical service.
ATTENTION: NEVER SHORT-CIRCUIT THE SECURITY PATH NOR USE A HIGHER
VALUE FUSE.
CAUTION: Fuse substitutions have to be performed by a qualified technician.
Audio Input Connections
INPUT 1 PHONO Turntable
INPUT 1 LINE CD or Digital Deck
INPUT 2 PHONO Turntable
INPUT 2 LINE CD or Digital Deck
INPUT 3 MICRO Microphone
INPUT 3 LINE CD or Digital Deck
To Next Page
Loading...
