12
HOUSE Output
This stereo output feeds the PA system through balanced XLR3 connectors (20) and
an unbalanced RCA connector (21). The nominal level of HOUSE output is set to 0dBV
(1Vrms) by default, but it can be set to +12dBV (4Vrms) using an internal dip-switch
(look at Configuration Diagram). The HOUSE output level is controlled by the HOUSE
potentiometer (14).
BOOTH Output
Commonly used as an independent local "Booth" output for the DJ . This stereo
BOOTH (19) has unbalanced RCA connections and its level is set at 0dBV (1Vrms) but
can be changed to +12dBV (4Vrms) through internal dip-switch (look at Configuration
Diagram). The BOOTH level is controlled by the BOOTH (15) potentiometer.
Record output
This output pair uses RCA type connectors. REC (24) is placed on the rear connection
panel. The nominal level of the REC output is 0dBV (1Vrms). This output is taken
post-fader, before the MASTER signal.
FX Send/Return effects loop
The RCA connectors on the FX SEND output (23) and the FX RETURN input (22) allow
creating a signal loop for external effects processors, samplers or sequencers. The
nominal level for the SEND output, as well as for the RETURN input, is 0dBV (1Vrms).
The signal sent to the FX SEND output can be taken before or behind the fader using
the PRE/POST switch (8) and the send level can be set using the related
potentiometer (9).
Headphones
In order to obtain the best performances, Headphones should be high impedance type
(200-600). Plug them in the MONITOR output (16) on the front panel: 1/4" and 1/8”
stereo jack are available for connection. Sleeve is Ground, Ring is Right Channel and
Tip is Left Channel.
To Next Page
Loading...
