Ecleris EVERLUX - Technical Specifications; Troubleshooting

USER MANUAL – EVERLUX
Page 9 de 11
INMANUUIN167 Rev.2019.04.01 / ENG
7. TECHNICAL SPECIFICATIONS
POWER SUPPLY VOLTAGE
100 -240V
Nº OF PHASES
1 (single phase)
FREQUENCY
50 – 60 Hz
PROTECTION AGAINST ELECTRICAL SHOCK
Class I
APPLIED PART
BF
PROTECTION LEVEL AGAINST WATER
ENTRANCE
IPX0
CONSUMPTION
110VA
FUNCTION MODE
Continuous
FUSES
2 x T3AL250V
COLOR TEMPERATURE
6000ºK approx.
LED SYSTEM SERVICE LIFE
Approx. 50000 hours
REFRIGERATION
Forced
OVER TEMPERATURE PROTECTION
Automatic LED system power-off
DIMMER
Electronic
FIBER OPTIC CONNECTOR
Universal fiber optic cable connector
(Revolving Turret)
VIDEO OUTPUT
Composite video (CVBS) (1 Vpp/75 Ω),
BNC
S-Video (Y/C), Jack mini-DIN
ECLERIS ENDODIGI CONNECTOR
Jack 3.5mm mono
DIMENSIONS
120x300x155mm (width x depth x high)
MASS
7.7 pounds
SERVICE CONDITIONS
50 – 104ºF
35 – 75% relative humidity
700 – 1060 hPa
STORAGE AND TRANSPORTATION
CONDITIONS
-22 – 122ºF
10 – 95% relative humidity
500 – 1060 hPa
8. TROUBLESHOOTING
The following table indicates the most common problems and their quick solutions. Please consult
this table for any difficulty you may encounter.
PROBLEM
PROBABLE CAUSE
ACTION
The equipment
does not turn on
It is not connected to the electrical
network
Connect the power supply cable
to the electrical network
The power supply cable is broken
or cut
Change the power supply cable
The plug is in bad condition
Change the plug
Fuse broken or burnt
Change the fuse