How to operate the tuner
21
V
Entering stations into memory
automatically
(The automatic preset mode:
ASM)
The automatic preset mode starts.
The [ASM ON] indicator on the screen
flashes, and stations are automatically
entered in memory under the buttons
[1] to [6].
These buttons are called preset
buttons.
ATTENTION
• Pressing the preset buttons ([1] to [6])
allows you to make one-touch station
selections. The frequency of the selected
station is indicated on the display.
• When a new station is set in memory, the
station previously set in memory will be
deleted.
• If there are fewer than six receivable
stations, the stations set in the remaining
buttons will be retained.
Manually setting stations into
memory
This section covers the setting of stations in
memory under the numbered buttons.
The tuned station is now memorized
and set in the selected button.
Repeat the procedure to set
additional manually tuned stations in
memory, in turn, for the buttons [1] to
[6]. These buttons are called the
preset buttons.
Preset station scan
This function enables reception of all the stations
in the preset buttons for five seconds each.
[P SCAN] will appear on the display,
and stations stored under the preset
buttons [1] to [6] will be played for
five seconds each.
The receiver will stay tuned to the
desired station.
1
Press the [SEL] button for more
than two seconds until a beep is
heard.
1
Turn the [SEL] button to the right
or left to tune to the station to be
entered in memory.
2
Select any button, from [1] to [6],
and press it for more than two
seconds.
1
Press the [SEL] button for less
than one seconds.
2
To stop the preset scan mode at a
desired station, press the [SEL]
button again.
To Next Page
Loading...
Need help?
General
