50 EC-11User’s Manual
03-32-00418-05 DALSA Corp.
Command Short
Form
Parameters Description
want to retrieve
get_camera_serial gcs Read the camera serial number
get_camera_version gcv Read the firmware version and
FPGA version
get_fpn_coeff gfc Value Read the FPN coefficient
get_prnu_coeff gpc Value Read the PRNU coefficient
get_line gl Get a line of raw video (no
digital processing or test
pattern) displaying one pixel
value after another and the
minimum, maximum, and
mean value of the sampled
line
get_line_average gla Read the average of 128 line
samples
get_sensor_serial gss Read the sensor serial number
help h Display the online help
reset_camera rc Reset the entire camera
(reboot)
reset_pixel_coeffs rpc Reset the pixel coefficients for
both directions to 0
restore_factory_settings rfs Restore the camera’s factory
settings. FPN and PRNU
coefficients reset to 0
restore_user_settings rus Restore the camera's last saved
user settings and FPN and
PRNU coefficients
set_analog_offset sao Value Set the analog offset. Offset
values range from 0 to 1023.
Offset increases with higher
values
set_binning_horizontal sbh Value Value 1 enables 2x binning.
Value 0 disables binning
set_binning_vertical sbv Value Value 1 enables 2x binning.
Value 0 disable binning
set_ccd_direction scd Value Set the readout direction and
updates direction dependent
parameters (except when
external input used):
0: Forward
1: Reverse
2: External input
set_digital_offset sdo Value Subtracts the input value from
the video signal prior to the
PRNU correction. Values
range from 0 to 511. Use in
calibrated mode only
set_fpn_coeff sfc Value Value Set the FPN coefficient. The
To Next Page