Eclipse EC-11-xxx40 - D7 Commands

EC-11 User’s Manual 49
DALSA Corp. 03-32-00418-05
Cod
e
Description
8 One (or more) of the supply voltages is out of specification.
9 The camera temperature is outside the specified operating range.
10 The camera memory check failed. Please report this error code to DALSA Inc.
11 User input under (over) limit. Setting set to high (low) limit.
12 Camera setting is under (over) specification limits.
13 FPGA communication error. Missing external or internal SYNC.
14 EEROM memory Read/Write error.
15 Video level out of range. FRN/PRNU calibration cancelled.
16 Calculated FPN/PRNU coefficients out of range. Calibration may be out of
specification.
17 Reserved.
18 General calibration failure
D7 Commands
Command Short
Form
Parameters Description
calibrate_analog_gain cag Value Calibrates the analog gain.
Values range from 128 to
250DN. This command
requires a constant light input
and only works in
uncalibrated mode
calibrate_analog_offset cao Value Calibrates the analog offset.
Values range from 1 to 100DN.
This command only works in
uncalibrated mode
correction_calibrate_fpn ccf Optional value Start FPN coefficient
calibration
correction_calibrate_prnu ccp Optional value Start PRNU coefficient
calibration
display_pixel_coeffs dpc Display the pixel coefficients
in the order PRNU, FPN,
PRNU, FPN, … for both
directions
endof_line_sequence els Value Set the end-of-line sequence:
0: Off
1: On
get_camera_model gcm Read the camera model
number
get_camera_parameters gcp Read all of the camera
parameters. Note: Sequence of
camera parameters may
change as new functionality is
added to the camera. When
possible, use commands
specific to the information you