Eco-Flo PUP61DC - Installation Instructions; General Installation Precautions; Warnings and Potential Damage; Electrical Wire Connection

Verify that the voltage and frequency of the pump shown on the name
plate corresponds to those available on the mains. The installer must
make sure that the electric system is grounded in accordance with code.
• Foroutdooruseitisnecessarytousecablewithalengthofatleast8’.Theplugandconnection
should be protected from water splashes. Before using the pump, always inspect it visually
(especially power cable and plug)
• Donotusepumpifitisdamaged
• Ifthepumpisdamaged,haveitinspectedbyanauthorizedservicecenter.
• Makesurethatelectricconnectionsareprotectedfromooding.Protecttheplugandthepower 
cable from heat or shape edges.
INSTALLATION
Do not work on pump until power is unplugged.
Donotcutoffgroundpinoruseanadaptertting.
Do not use an extension cord.
The pump power cord should be connected to
a grounded line with a minimum capacity of 15
amps.
1. Before installing or servicing this pump, be
certain pump source is disconnected.
2. Installationandelectricalwiringmustadhere
to state and local codes and must be
completed before priming pump. Check
appropriate community agencies, or contact
local electrical and pump professionals.
3. Call an electrician when in doubt.
Note that plugging into existing outlets may
cause low voltage at motor. This could cause
blown fuses, tripping of motor overload or
burned out motor.
4. Formaximumsafety,connectpumptoa 
circuit equipped with a fault interrupter
 devicewhenpositioningthepump’s 
grounding wire.
5. Voltage of power supply must match the
voltage of the pump.
6. Before installing pump, clear of any debris or
sediment.
The power cable must be replaced by qualied personnel only.
Grounding: The plug of the power cable has a double grounding contact,
so that grounding can be performed by simply inserting the plug.
This pump series has a built in thermal protection switch. The pump stops if an overload
condition occurs. The motor restarts automatically after it has cooled down.
7. The following may cause severe damage to
pump and will void the warranty.
(a) Using an extension cord.
(b) Cutting off the ground pin or using an
 adaptertting.
(c) Working on pump or switch while
plugged in.
(d) Removing motor housing, unscrewing
impeller, or otherwise removing
impeller seal.
(e) Running the pump continuously.
(f) Pumping chemicals or corrosive
liquids, other than motor oil.
 (g) Pumpinggasolineorotherammable 
liquids
(h) All piping must be clean and free of all
foreign matter to prevent clogging.
( l ) Pump will be inadequate if suspension
liquids contain solid particles larger than 1/4”.
2
ELECTRICAL WIRE CONNECTION
OVERLOAD PROTECTION
For parts or assistance, call ECO-FLO Customer Service at 1-877 326-3561