P
perkinskaitlinJul 29, 2025
Why is there a low flow rate with my Eco-Flo Water Pump?
- MMichael ColeJul 29, 2025
A low flow rate in your Eco-Flo Water Pump may be due to several reasons. The drill might be running too slowly; increase the drill speed to at least 800 RPM, ideally 3500 RPM. There could be a restriction in the inlet or discharge hoses; clean or replace the hoses and ensure there are no sharp bends or kinks. Also, the suction hose might be too long or too small in diameter, or the pump is positioned too high above the liquid surface; use an appropriate hose and pumping setup to maximize performance.