Eco Physics CLD 780 TR - Introduction; Safety Precautions

E C O P H Y S I C S Introduction
CLD 780 TR / July 2000 3
1.2 Safety precautions
This section summarizes the safety precautions, which are to be observed
without exception when using the CLD 780 TR analyzer (in the following
sections called “analyzer“).
For all persons working with the analyzer, reading and comprehending
the sections relevant to their work is obligatory. This is especially valid for
this section, the reading of which is binding for all persons operating the
analyzer, including those using it only temporarily or occasionally, e.g.
for service purposes.
1.2.1 Definitions, Personnel, Definitions of terms
– Supplier
The supplier is ECO PHYSICS AG in CH-8635 Duernten, Switzerland
and all other persons who claim to be the supplier by marking the ana-
lyzer with their name, their logo or any other distinguishing label.
Furthermore the representative or the importer of the analyzer or other
commercial businesses in the distribution channel acts as supplier, as
far as their activities influence the safety conditions of the analyzer.
–End user
The end user is the local owner of the analyzer. He is responsible for
the intended use (see below).
Qualifications of the operating personnel
(I.e. all persons involved with the analyzer)
– General operation:
Installation, operation, calibration and periodic maintenance must be
performed by personnel who have attended technical courses and
have adequate instrument-related skills. This basic knowledge allows
them to estimate potential risks and hazards in the use of the analyzer
and its accessories. Alternatively, these persons have been specifically
trained in order to comply with these requirements.