12
DRAINING YOUR SPA
Drain and refill your ECO SPA with fresh water to the recommended level as necessary.
Depending on the frequency and length of your spa sessions and water quality management,
you may have to do so more or less frequently.
Hint: once water chemistry becomes difficult to control and/or maintain properly, the water
needs to be changed.
Unplug or disconnect the ECO SPA’s electrical power supply. The ECO SPA must
remain unplugged until re-filled with water.
Rotate the Air Controls to the fully OPEN position.
Remove the cap from the ECO SPA's Drain valve and connect it to a standard garden
hose. Place the opposite end of the garden hose in the desired drainage area and twist
the knob on the ECO SPA’s Drain Valve to open it and commence draining.
WINTERIZING
If your ECO SPA is to be transported or stored in temperatures 32º F (0º C) or lower, it is
critical that your ECO SPA be fully winterized.
The ECO SPA must be fully drained and emptied. (See DRAINING YOUR SPA, above)
1. The Drain Valve must remain in the open position with the Drain Valve Cap removed
and stored.
2. The Filter Cartridges must be removed, dried and stored.
3. Unscrew and remove the plug located at the bottom of the pump housing. The pump is
located behind the panel with the louvered vent. (For the location of this panel on your
spa, see the diagram of your model on pages 23 -26).
To Next Page
Loading...
