To Next PageTo Next Page
Need help?Do you have a question about the Eco Spa E4 and is the answer not in the manual?
Instructions to prevent electric shock, including grounding.
Warning against removing suction fittings to prevent injury.
Tips to reduce injury risk, including water temperature limits.
Information on hyperthermia risks and symptoms from hot tub use.
Avoid electrical appliances near the spa to prevent shock.
Children must be supervised when using the spa.
Ensure suction guards are installed to prevent entrapment.
Consult a physician if using medications or with adverse medical history.
Individuals with infectious diseases should not use the spa.
Exercise care when entering or exiting the spa.
Avoid drugs or alcohol to prevent drowning.
Pregnant women should consult a physician before spa use.
Excessive water temperature can be injurious to health.
Measure water temperature with an accurate thermometer.
Do not use the spa immediately after strenuous exercise.
Prolonged immersion in the spa may be injurious to health.
Keep electric appliances away from the spa.
Guidance on choosing a suitable location for the spa.
Do not use shims or wedges; ensure 100% floor contact.
Ensure spa area is not accessible to children; use fencing.
Details for operating the spa at 110 Volts, including GFCI.
Do not plug in the power cord until the spa is completely filled.
Requirements for 220 Volt operation, including hiring an electrician.
Ensure power is OFF and cord is unplugged before filling.
Verify the drain valve is closed and capped securely.
Fill the spa to 2 inches above the highest jet.
Plug in GFCI and press reset; observe display for codes and temp.
Heater automatically activates to reach the programmed temperature.
Steps to winterize the spa for storage in freezing temperatures.
System checks water flow to prevent heater damage from dry firing.
Caution against stopping flow to all jets simultaneously to prevent pump damage.
Work on spa systems only if qualified; test GFCI.
Procedure to test and verify GFCI operation for safety.
How to access and set the GFCI breaker rating.
General