11
CARE AND MAINTENANCE INSTRUCTIONS
HARD COVERS & SPA SURFACES
When not in use please keep your ECO SPA hard covers clamped down at all times,
especially in extreme weather conditions. Consistent use of the clamps will help maintain the fit
of the covers to the spa.
CLEANING YOUR ECO SPA
The high-grade resin from which your ECO SPA is constructed can easily be cleaned with a
vinegar and water solution.
CLEANING THE FILTER CARTRIDGES
The filter cartridges should be rinsed and cleaned at least once every month or more frequently
for high bather loads. You may wish to also soak excessively dirty cartridges overnight in filter
cartridge cleaner solution; if you do, be sure to rinse them out thoroughly before re-installing.
Disconnect power to your ECO SPA.
Remove the filter cover.
Remove the filter cartridges from their sockets by unscrewing them (counter clockwise).
Attach a filter cleaner nozzle to your garden hose and rinse dirt and debris from the
cartridge pleats thoroughly.
Allow the filter cartridges to air dry completely before reinstalling them. Drying allows
the fabric of the cartridges to expand properly in order to filter effectively.
Replace the filter cartridges, aligning them with care to not ‘cross-thread’ them in their
sockets. Do not tighten them excessively.
Reinstall the Filter Cover.
Power to your ECO SPA can then be turned back on.
It is best and easiest to pull the
covers open and down from the ends
of the spa using the handles as this
helps to maintain even weight
balance.
Lifting the covers by one side or the
other instead of pulling them open in
this manner puts undue stress on the
lifter arm(s) due to the unbalanced
weight.
To Next Page
Loading...
