11
CARE AND MAINTENANCE INSTRUCTIONS
HARD COVERS & SPA SURFACES
When not in use please keep your ECO SPA hard covers clamped down at all times, especially
in extreme weather conditions. Consistent use of the clamps will help maintain the fit of the
covers to the spa.
CLEANING YOUR ECO SPA
The high-grade resin from which your ECO SPA is constructed can easily be cleaned with a
vinegar and water solution.
CLEANING THE FILTER CARTRIDGES
• Remove tray top to change filters
• Attach provided filter cleaner nozzle to your garden hose and rinse dirt and debris from
the cartridge pleats thoroughly.
• To clean or replace filters, unscrew filter (counterclockwise). Replace it before replacing
second filter.
• Do not tighten them excessively.
• Reinstall the Tray Top.
• Recommended filter replacement is the FILBUR FC-0359 or the PRO-LINE P6CH-940.
It is best and easiest to pull the
covers open and down from the ends
of the spa using the handles as this
helps to maintain even weight
balance.
Lifting the covers by one side or the
other instead of pulling them open in
this manner puts undue stress on the
lifter arm(s) due to the unbalanced
weight.
The filter cartridges should be rinsed and cleaned at
least once every month or more frequently for high
bather loads. You may wish to also soak excessively
dirty cartridges overnight in a filter cartridge cleaner
solution; if you do, be sure to rinse them out thoroughly
To Next Page
Loading...
