10
from heat, moisture or flammable materials. In addition, it cannot be covered. When
charging the battery, please observe the following steps:
A. Insert the charger plug into the socket in the battery, and then connect the charger
cable to the power socket.
B. When the charger light is red, the battery is charging. When the red light turns green it
means that the battery is fully charged (Fig.1).
C. After charging is complete, disconnect the cable from the wall outlet first and then from
the battery.
D. Never leave the rechargeable battery unattended.
10. ELECTRIC MOTOR
✓ Do not use the bicycle during heavy rain or during a storm because it can be
damaged.
✓ Check regularly that the screws are tight on both sides of the rear hub.
✓ Always make sure that the cables leading to the motor are securely connected.
✓ Never try to make any repairs to the engine in your own.
11. DISPLAY LED
11.1 BUTTON DESCRIPTION
1. Press the ON / OFF button on the display to activate and deactivate the power
system.
2. The four LEDs that light up show the battery charge status. When the 4 lights are on
the battery is charged. When only 1 light are on - charge the battery.
3. The bike has 3 driving modes (LOW; MEDIUM; HIGH).
➢ In LOW mode the speed of the power is about 5km/h, in the MED mode, about
15km/h, in HIGH mode about 25 km/h.
To Next Page
Loading...
