Ecobike LCD C900 USB - User Manual

1
1. USER MANUAL LCD C900 USB
1.1. REMOTE AND DISPLAY APPEARANCE
1.2. TURNING ON / OFF THE DISPLAY
Press and hold the ON / OFF button for 3 seconds to turn the
LCD on or off.
➢ When the display is off, there is no battery
consumption. The current flow is not more than 2 µA.
➢ The panel will revert to sleep mode when the speed is
5 minutes level 0 km / h.
1.3. MOTOR POWER INDICATION
Indicates the power with which the motor works, when the
entire power bar is displayed, this means that the motor
works at full power. The battery is discharged faster then.
1.4. BATTERY SOC INDICATOR
The battery level is indicated by symbol located in the battery
symbol in the upper left corner of the display. Each missed
part of the symbol corresponds to 20% battery charge.
Remember to give more attention to the BMS (voltage), than
to battery indicator.
1.5. WALK ASSISTANCE
Press and hold the "MINUS" button to start the motor that will
go at 6km / h without pedaling. The display will show the
icon as in the picture beside. When the user releases the
button, the engine will automatically shut down.

Summary

1. USER MANUAL LCD C900 USB

1.1. REMOTE AND DISPLAY APPEARANCE

Describes the physical layout and components of the remote and LCD display.

1.2. TURNING ON; OFF THE DISPLAY

Instructions for powering the LCD display on and off, including sleep mode behavior.

1.3. MOTOR POWER INDICATION

Explains how motor power is shown on the display and its relation to battery discharge.

1.4. BATTERY SOC INDICATOR

Details on how the battery level is displayed and advice on interpreting it.

1.5. WALK ASSISTANCE

How to activate and use the walk assistance feature for low-speed movement.

1.6. BACKLIGHT AND LIGHT INDICATION

How to control display backlight and turn on/off bike lights.

1.7. MOTOR ASSISTANCE LEVEL SELECTION

How to adjust the electric assistance levels (0-6).

1.8. ERROR INDICATION

Explains error codes and what to do if they appear on the display.

2. USER SETTINGS

2.1. ENTER THE SETTINGS MENU

Steps to access the user settings menu via button combinations.

2.2. RESETTING THE TRIP DISTANCE

How to reset the trip distance data and save the setting.

2.3. UNIT SETTING

Instructions for changing the unit of measurement (Metric/Imperial).

2.4. WHEEL SIZE SETTING

How to set the wheel size and its impact on data accuracy.

2.5. LCD LUMINANCE

Adjusting the brightness of the LCD backlight.

3. ADVANCED SETTINGS

3.1. ADVANCED SETTINGS MENU

How to enter the advanced settings menu using a password.

3.2. ELECTRIC ASSISTANCE LEVEL RANGE

Selecting the range of available electric assist modes (e.g., 0-8).

3.3. VOLTAGE SETTING

Setting the battery voltage values for the display bar.

Ecobike LCD C900 USB Specifications

General

Brand	Ecobike
Model	LCD C900 USB
Category	Bicycle Accessories
Language	English