Need help?Do you have a question about the Ecoflam MINOR 12.1 and is the answer not in the manual?
Graphical representation of burner operating ranges based on pressure and output.
Maximum lengths for suction lines in two-pipe systems (siphon feed and lift).
Calibration data for nozzle, pump, fuel flow rate, and air damper settings.
Instructions for safely removing, cleaning, and replacing the burner nozzle.
Steps for initial burner start-up, safety checks, and functional adjustments.
Procedure for adjusting the combustion head for optimal performance.
How to adjust the air damper for proper air-fuel mixture.
Instructions on how to disassemble the blast tube for maintenance.
Diagram and notes on electrical connections required by the installer.
Common causes and checks when the burner fails to initiate operation.
Troubleshooting steps for when the burner does not ignite after the prepurge cycle.
Diagnosing and resolving issues where the burner shuts down shortly after ignition.
To Next Page
General