Ecoflam Blu 700 PR/MD - User Manual

LB381
13.07.2004
A BRUCIATORI A GAS PROGRESSIVI E MODULANTI
B
MODULATING AND PROGRESSIVE GAS BURNERS
C BRULEURS GAZ PROGRESSIVES ET MODULANTS
D QUEMADOR DE GAS PROGRESIVOS EN MODULANTE
Blu 500 PR / MD
Blu 700 PR / MD
Blu 1000 PR / MD
Blu 1200 PR / MD
Blu 1400 PR / MD
Metano (G20) / G.P.L.(G30-G31)

Summary

WORKING FIELDS

ELECTRICAL CONNECTIONS

CONNECTION TO THE GAS PIPELINE

START UP OF THE BURNER

IMPORTANT ADVICE

ADJUSTING THE COMBUSTION

FAULT DISPLAY MESSAGES

AIR ADJUSTMENT

Adjusting the maximum capacity of the burner

Adjusting the minimum capacity of the burner

CALCULATION OF WORKING OUTPUT OF THE BURNER

COMBUSTION ADJUSTMENT

SETTING THE FIRING HEAD

ADJUSTMENT OF GAS MINIMUM PRESSURE SWITCH

ADJUSTMENT OF THE AIR PRESSURE SWITCH

IONIZATION CURRENT

RWF 40 MICROPROCESSOR REGULATOR

PROGRAMMING LEVELS

SETTING PARAMETERS

Changing the set point

Setting PID Parameters

Adjusting PID control parameters (Pb1, dt, rt).

Differential Setting for Ignition and Shutoff

PROBE CONNECTION DIAGRAMS

C111 - C112 INPUT CONFIGURATION INDICATIONS

ERROR;FAULT INDICATION NUMBERS BLINKING IN DISPLAY

MAINTENANCE

ANNUAL CHECK

IF THE BURNER FAILS TO START:

Troubleshooting start-up failures.

IF THE BURNER PROCEEDS WITH PREVENTILATION BUT CUTS OUT AT THE END OF THE CYCLE:

Troubleshooting preventilation cut-outs.

IF THE BURNER PROCEEDS WITH PREVENTILATION BUT DOES NOT LIGHT:

Troubleshooting no-light issues.

IF THE BURNER LIGHTS BUT CUTS OUT AFTER THE SAFETY INTERVAL:

IF THE BURNER LIGHTS BUT CUTS OUT AFTER OPERATING FOR A FEW MINUTES:

PARAMETERS

CONFIGURATION

Ecoflam Blu 700 PR/MD Specifications

General

Fuel Type	Natural Gas / LPG
Control Type	Electronic
Voltage	230 V
Frequency	50 Hz
Efficiency	Up to 94%
Stages	Two Stage