Need help?Do you have a question about the Ecoflam BLU 500 P and is the answer not in the manual?
Technical specifications for BLU 500 P and BLU 700 P models, including power and pressure.
Graphical representation of burner operating ranges based on output and backpressure.
Diagrams and measurements detailing the physical size of the BLU 500 P and BLU 700 P burners.
Procedures for safely connecting the burner to the gas supply and electrical systems.
Steps for burner start-up, including preliminary checks, advice, and combustion tuning.
Details on the normal and flameless operative cycles of the burner control system.
Information on the Satronic DLG 976 micro-processor control unit and its functions.
Explanation of fault display messages, codes, and the flash-code key for diagnosis.
Procedure for calculating burner output in kW based on gas flow and measurement time.
Instructions for adjusting firing head position and electrode gap for optimal combustion.
Procedure for converting the burner between natural gas (G20-G25) and LPG (G30-G31).
Steps to set minimum gas pressure and air pressure switches for correct burner operation.
Procedure for testing the burner's flame detection system using a microammeter.
Identification and function of the components on the burner's control panel.
Guidance on annual maintenance, pre-intervention checks, and troubleshooting common burner operational faults.
To Next Page
General