Need help?Do you have a question about the Ecoflam Blu 5000.1 PR and is the answer not in the manual?
Connecting gas pipeline, checking seals, and verifying electrical connections.
Steps for initial burner start-up, including preliminary checks.
Guidelines for optimizing combustion and thermal capacity via analysis.
Illustrates normal and ignition failure operating cycles for the Landis & Staefa LFL1.622.
Details on adjusting cams for the Landis & Staefa SQM 50.481A2 air damper motor.
Adjusting minimum, maximum, and intermediate burner capacities for air and gas.
Formula and process for calculating the burner's output capacity in kilowatts.
Instructions for setting the firing head, ignition electrode, and ionization probe.
Procedures for adjusting gas minimum and air pressure switches.
Method for measuring ionization current to ensure proper flame detection.
Diagram showing the steps to disassemble the burner's firing head for maintenance.
Identification and description of the various components on the burner's control panel.
Explanation of the RWF 40 regulator's display elements and key functions.
Overview of the different menu levels for programming the RWF 40 regulator.
Modifying set points, PID parameters, and ignition/shutoff differentials.
Switching modes and configuring climate compensation with external probes.
Graphical data relating boiler temperature set point to external temperature and gradient.
Schematics detailing the correct wiring for various temperature and pressure probes.
Configuration settings for analog inputs, setpoint, and unit address.
Configuration of auxiliary contact type and set point interlock to external probe.
Explanation of display errors (1999 blinks) and their causes/remedies.
Annual checks and procedures for cleaning and inspecting burner components.
Essential safety and system checks before performing any maintenance or repair.
Diagnostic steps for common issues preventing burner start or operation.
Table detailing parameters, display codes, and default settings for different probes.
Configuration codes for analog inputs, setpoints, limits, and corrections.
To Next Page
General