To Next PageTo Next PageWhat to do if Ecoflam MAX GAS 500 P Burner lights but cuts out after safety interval?
If your Ecoflam Burner lights but cuts out after the safety interval, make sure that the phase and neutral wires are connected correctly. Also, check the gas solenoid valve, the position and connection of the detector electrode, and the detector electrode itself. Finally, check the safety device.
What to do if Ecoflam MAX GAS 500 P lights but cuts out after a few minutes?
If the Ecoflam Burner lights but cuts out after operating for a few minutes, begin by checking the pressure regulator and gas filter. Next, use a pressure gauge to check the gas pressure. Finally, check the detector value, ensuring it's at least 3 µA.
How to troubleshoot Ecoflam MAX GAS 500 P that fails to start?
If the Ecoflam Burner fails to start, you should check the switch, the thermostats, the motor, and the gas pressure.
What to do if Ecoflam MAX GAS 500 P proceeds with prevention but does not light?
If the Ecoflam Burner proceeds with prevention but does not light, check the installation and position of the electrodes. Also, check the ignition cable, the ignition transformer, and the safety device.
General| Category | Burner |
|---|---|
| Model | MAX GAS 500 P |
| Efficiency | Up to 95% |
| Control System | Electronic Modulation |
| Fuel | Natural Gas |
| Stages | Two-stage |
| Gas train | Included |
| Ignition | Electronic |
| Air Regulation | Automatic |
| Applications | Industrial heating |
Describes safety mechanisms and operational limits of the burner.
Details the connection diagram and control sequence of the Siemens LME21 unit.
Identifies and explains the components of the burner's control panel.
Details the process of fixing the burner to the boiler using the connecting flange.
Covers electrical installation, connection, and pre-commissioning checks for the burner.
Explains how to regulate the combustion of the one-stage burner and set the firing head.
Details the calibration of the air pressure switch and setting of the gas pressostat.
Provides guidance on burner and boiler servicing, including exhaust gas temperature checks.
Guides on fault diagnosis, repair, and error code interpretation for burner malfunctions.
