What to do if Ecoflam MAX GAS 350 P lights but cuts out after safety interval?
If your Ecoflam Burner lights but cuts out after the safety interval, make sure that the phase and neutral wires are connected correctly. Also, check the gas solenoid valve, the position and connection of the detector electrode, and the detector electrode itself. Finally, check the safety device.
What to do if Ecoflam Burner lights but cuts out after a few minutes?
If the Ecoflam Burner lights but cuts out after operating for a few minutes, begin by checking the pressure regulator and gas filter. Next, use a pressure gauge to check the gas pressure. Finally, check the detector value, ensuring it's at least 3 µA.
How to troubleshoot Ecoflam MAX GAS 350 P Burner that fails to start?
If the Ecoflam Burner fails to start, you should check the switch, the thermostats, the motor, and the gas pressure.
What to do if Ecoflam MAX GAS 350 P Burner proceeds with prevention but does not light?
If the Ecoflam Burner proceeds with prevention but does not light, check the installation and position of the electrodes. Also, check the ignition cable, the ignition transformer, and the safety device.
Visual guide for boiler mounting procedures.
Details on power supply and wiring for motors and auxiliary equipment.
Instructions for gas line connection and sealing checks.
Instructions for installing and setting up PAB version gas trains.
Step-by-step guide for burner ignition and initial checks.
Procedure for setting ignition gas flow rate below 120 kW.
Procedure for adjusting minimal gas flow on PAB models.
Guide to adjusting cams on the air servomotor for damper control.
Steps for regulating combustion in PAB and P versions.
Guidance on adjusting air and gas pressure switches.
Wiring and sequence diagrams for control boxes.
Instructions for adjusting the firing head and air flow.
Checks for flame detection and correct electrode positioning.
Step-by-step visual guide for removing the firing head.
Table detailing error codes, LED blinks, and possible causes.
Explanation of the burner's control panel components.
Recommended periodic maintenance tasks and pre-intervention checks.
Checklist for common burner startup and operational failures.
To Next Page
General